DCD

Anchor Shackle 3/8" Screw Pin Type Swl 2,000 Lb

These shackles provide a low cost, economical means of connecting two products together. They are available in two types: one with a bolt, nut and cotter pin for locking (00654 series), the...

6" x 5-1/2" Dia. Spreader Disc

Lube Spreader This two-part product is designed to spread DCD Tube-Lube® 346 (or similar) around the walls and along the length of the duct, while also acting as a connector. The body is...

140mm Sealed Duct Puller

These Duct Pullers are the same as the 00650 series, but are designed with jaws that allow sizing to metric duct sizes. These products are designed to install polyethylene ducting using expanding...

Rope-swivel Connector - 15,000 lb, 7/8" rope max

This product is used to connect a swivel to pulling rope. The entire product, including sheave, is manufactured from stainless steel. Replacement sheaves are available by contacting Customer...

Duct Puller 10" Sdr 9 Duct

These products are designed to grip polyethylene ducting using expanding jaws to grip the inside wall of the duct. This causes the pulling load to be spread around the circumference of the duct and...

Anchor Shackle 1/4" Screw Pin Type Swl 1,000 Lb

These shackles provide a low cost, economical means of connecting two products together. They are available in two types: one with a bolt, nut and cotter pin for locking (00654 series), the...

Anchor Shackle 1/2" Screw Pin Type Swl 4,000 Lb

These shackles provide a low cost, economical means of connecting two products together. They are available in two types: one with a bolt, nut and cotter pin for locking (00654 series), the...

Breakaway Pin Kit 2700 lb, 5/kit

Originally, the DCD breakaway connectors were used by contractors installing gas ducting where it is critical to protect the duct from overload during installation. Many utilities now require the use...

Breakaway Wire Kit 150 lb, 10/kit

This connector uses a wire instead of a pin to achieve the smallest of break loads. The two-piece design ensures you don’t lose parts of your connector when separation does occur. The...

Duct Puller 140 mm Duct

These Duct Pullers are the same as the 00620 series, but are designed with jaws that allow sizing to metric duct sizes. These products are designed to grip polyethylene ducting using expanding jaws...

7/8" Dia. Connector Body

Lube Spreader This two-part product is designed to spread DCD Tube-Lube® 346 (or similar) around the walls and along the length of the duct, while also acting as a connector. The body is...

Duct Puller 6" Duct

These products are designed to grip polyethylene ducting using expanding jaws to grip the inside wall of the duct. This causes the pulling load to be spread around the circumference of the duct and...