All Products

Support Grip - Stainless Steel 1.00" - 1.24" Dia (P/N 00802-098S)

Cable Support Grips are used for supporting any kind of cable in permanent installations. They can be used in either horizontal or vertical installations to relieve the cable weight from connections and fixtures. DCD grips are manufactured of durable...

Pulling Grip 1.13" - 1.49" Dia (P/N 00664-030)

Hand-woven by experienced tradespeople in order to guarantee a consistent level of high quality, DCD Pulling Grips enclose the cable firmly over the entire length of the mesh. They are made of high tensile steel strands. Depending on the type of grip,...

PORCUPINE EXTREME ROCK DRILLING BIT 4-1/4" Cut With 2.0" IF Pin

American HDD® Rock Bits are designed for easy cutting and steering in soft and medium-hard rock. The large face aids in steering while the carbide rubble hard-facing and carbide cutters and wear buttons,insure long service life. Pick the Extreme Series...

Support Grip - Stainless Steel 1.00" - 1.24" Dia (P/N 00801-098S)

Cable Support Grips are used for supporting any kind of cable in permanent installations. They can be used in either horizontal or vertical installations to relieve the cable weight from connections and fixtures. DCD grips are manufactured of durable...

Compatible Transmitter Housing Ditch Witch® Compatible 3.250" Dia., Box x Box Side Load Housing, 2.375" REG x 2.375" REG

CLOCKING MECHANISM End Load Rock Housing Transmitter Retaining Cap Elastomer

SEQUOIA® ROCK DRILLING BIT With Angle Cutters 7" cut with 3-1/2" API Reg Pin

American HDD® Rock Bits are designed for easy cutting and steering in soft and medium-hard rock. The large face aids in steering while the carbide rubble hard-facing and carbide cutters and wear buttons,insure long service life. Pick the Extreme Series...

Support Grip 2.50" - 2.99" Dia (P/N 00802-252)

Cable Support Grips are used for supporting any kind of cable in permanent installations. They can be used in either horizontal or vertical installations to relieve the cable weight from connections and fixtures. DCD grips are manufactured of durable...

Pulling Grip 2.00" - 2.49" Dia (P/N 00682-048)

Hand-woven by experienced tradespeople in order to guarantee a consistent level of high quality, DCD Pulling Grips enclose the cable firmly over the entire length of the mesh. They are made of high tensile steel strands. Depending on the type of grip,...

Support Grip - Stainless Steel 1.50" - 1.99" Dia (P/N 00810-150S)

Cable Support Grips are used for supporting any kind of cable in permanent installations. They can be used in either horizontal or vertical installations to relieve the cable weight from connections and fixtures. DCD grips are manufactured of durable...

Duct Puller 3" Duct (P/N 00620-300)

These products are designed to grip polyethylene ducting using expanding jaws to grip the inside wall of the duct. This causes the pulling load to be spread around the circumference of the duct and allows a maximum load to be applied without damage to...

DIRT SUBS FOR BOX END TRANSMITTER HOUSING(Blade Adapters) Ditch Witch® Compatible 6 bolt (16MM) 2-7/8" REG PIN, FOR 4" DIAMETER HOUSING