All Products

Can-link Connector 1-1/2" Dia, 9,000 lb

The Can-Link™ Connector is used to connect two items with lugs or wire loop fittings. A common use is to connect a wire mesh grip to the pulling wire. The connectors are manufactured from high strength stainless steel with hardened clevis...

Duct Plugger Kit 4" Duct

Breakaway Pin Kit 4000 lb, /kit

Originally, the DCD breakaway connectors were used by contractors installing gas ducting where it is critical to protect the duct from overload during installation. Many utilities now require the use of a breakaway connector to ensure the final integrity...

Duct Sleeve 110 Mm Duct

Breakaway Pin Kit 800 lb, 10/kit

Originally, the DCD breakaway connectors were used by contractors installing gas ducting where it is critical to protect the duct from overload during installation. Many utilities now require the use of a breakaway connector to ensure the final integrity...

Duct Plugger Kit 110 Mm Duct

6" x 5-1/2" Dia. Spreader Disc

Lube Spreader This two-part product is designed to spread DCD Tube-Lube® 346 (or similar) around the walls and along the length of the duct, while also acting as a connector. The body is constructed out of stainless steel and the polyurethane...

140mm Sealed Duct Puller

These Duct Pullers are the same as the 00650 series, but are designed with jaws that allow sizing to metric duct sizes. These products are designed to install polyethylene ducting using expanding jaws to grip the inside diameter of the duct while the...

Rope-swivel Connector - 15,000 lb, 7/8" rope max

This product is used to connect a swivel to pulling rope. The entire product, including sheave, is manufactured from stainless steel. Replacement sheaves are available by contacting Customer Service. The sheaves run on standard DCD clevis pins,...

Duct Puller 10" Sdr 9 Duct

These products are designed to grip polyethylene ducting using expanding jaws to grip the inside wall of the duct. This causes the pulling load to be spread around the circumference of the duct and allows a maximum load to be applied without damage...

Breakaway Pin Kit 2700 lb, 5/kit

Originally, the DCD breakaway connectors were used by contractors installing gas ducting where it is critical to protect the duct from overload during installation. Many utilities now require the use of a breakaway connector to ensure the final integrity...

Breakaway Wire Kit 150 lb, 10/kit

This connector uses a wire instead of a pin to achieve the smallest of break loads. The two-piece design ensures you don’t lose parts of your connector when separation does occur. The product is manufactured from stainless steel to...