All Products

Breakaway Wire Kit 200 lb, 10/kit

This connector uses a wire instead of a pin to achieve the smallest of break loads. The two-piece design ensures you don’t lose parts of your connector when separation does occur. The product is...

Breakaway Pin Kit 1,000 lb, 10/kit

Originally, the DCD breakaway connectors were used by contractors installing gas ducting where it is critical to protect the duct from overload during installation. Many utilities now require the use...

Duct Plugger Kit 8" Duct

Duct Puller 140mm Duct

Duct Plugger Kit 6" Duct

Rope-swivel Connector 30,000 lb w/o sheave

This product is used to connect a swivel to pulling rope. The entire product, including sheave, is manufactured from stainless steel. Replacement sheaves are available by contacting Customer Service...

Dub-wise Puller 1-1/4" Duct

These products are designed to install polyethylene ducting using expanding jaws to grip the inside diameter of the duct while the outside diameter is prevented from stretching by a permanent outer...

Breakaway Pin Kit 500 Kg 5/kit

Originally, the DCD breakaway connectors were used by contractors installing gas ducting where it is critical to protect the duct from overload during installation. Many utilities now require the use...

Duct Puller 200 mm Duct

These Duct Pullers are the same as the 00620 series, but are designed with jaws that allow sizing to metric duct sizes. These products are designed to grip polyethylene ducting using expanding jaws...

Can-link Connector 1-1/2" Dia, 9,000 lb

The Can-Link™ Connector is used to connect two items with lugs or wire loop fittings. A common use is to connect a wire mesh grip to the pulling wire. The connectors are manufactured from high...

Duct Plugger Kit 4" Duct

Breakaway Pin Kit 4000 lb, /kit

Originally, the DCD breakaway connectors were used by contractors installing gas ducting where it is critical to protect the duct from overload during installation. Many utilities now require the use...