All Products

Dub-wise Puller 1-1/2" Duct

These products are designed to install polyethylene ducting using expanding jaws to grip the inside diameter of the duct while the outside diameter is prevented from stretching by a permanent outer...

Breakaway Pin Kit 1800 lb, 5/kit

Originally, the DCD breakaway connectors were used by contractors installing gas ducting where it is critical to protect the duct from overload during installation. Many utilities now require the use...

Duct Sleeve 3" Duct

Duct Sleeve 50 Mm Duct

110mm Sealed Duct Puller

These Duct Pullers are the same as the 00650 series, but are designed with jaws that allow sizing to metric duct sizes. These products are designed to install polyethylene ducting using expanding...

Duct Puller 1-1/2" Duct (P/N 00620-150)

These products are designed to grip polyethylene ducting using expanding jaws to grip the inside wall of the duct. This causes the pulling load to be spread around the circumference of the duct and...

5" Polyurethane Duct Puller

Duct Plugger Kit 140 Mm Duct

Anchor Shackle 1-1/2" Screw Pin Type Swl 34,000 Lb

These shackles provide a low cost, economical means of connecting two products together. They are available in two types: one with a bolt, nut and cotter pin for locking (00654 series), the other...

Breakaway Wire Kit 22 lb, 10/kit

This connector uses a wire instead of a pin to achieve the smallest of break loads. The two-piece design ensures you don’t lose parts of your connector when separation does occur. The product is...

Duct Puller 12" Sdr 11 Duct

These products are designed to grip polyethylene ducting using expanding jaws to grip the inside wall of the duct. This causes the pulling load to be spread around the circumference of the duct and...

50mm Sealed Duct Puller

These Duct Pullers are the same as the 00650 series, but are designed with jaws that allow sizing to metric duct sizes. These products are designed to install polyethylene ducting using expanding...